How to fill a CO2 Tank

With a pin valve tank

These instructions are only apply for using a deluxe fill station (2 on/off
valves)

1. make sure both valves are closed
2. open big tanks valve
3. screw on small tank
4. screw pin valve down so valve is open
5. add 2 to 4 ounces to cool tank
6. close valve
7. open release valve (to empty 2-4 ounces)
8. close release valve
9. fill tank to full capacity
10. close pin valve
11. open release valve
12. unscrew tank
13. close main tank valve
release the air in the fill station

**Make sure that someone experienced is there to make sure you are filling properly.**

Disclaimer:

P and R Online is not responsible for any  injury or other harm to you for following any of the instructions on this page.  By reading this and accessing this page you are showing compliance with this disclaimer.  Please note that filling Co2 or N2 requires special permits.